With the development of drill grinder equipment, drill grinders are now used more and more widely. In particular, the Micra-10 small drill grinder manufactured by Demina. This equipment is grinding machine equipment developed and produced by our company's technical staff. This equipment has superior performance and high grinding efficiency and will be used by users once it is promoted. However, there are still some issues to be aware of when using it.
Steps for the usage of small drill grinder
1. First, confirm the material of the drill bit, select the appropriate grinding wheel according to the material of the drill bit, and install it on the equipment.
2. Confirm the diameter of and select the collet configured by the equipment according to the diameter of the drill bit. Generally, the collet is ER20 or ER25 or ER40. Each manufacturer uses different standards and equipment sizes.
3. Select the accessories and then clamp, adjust the grinding amount, turn on the Demina drill grinder, run the equipment, and observe the operation of the equipment.
4. The equipment is operating normally, and the grinding machine is started. First, the grinding of the corners is performed, and the corners of the corners are ground. The size of the horizontal blade can generally be adjusted through the screw above the grinding point of the static point of the equipment. This adjustment must also be adjusted according to the diameter of the drill.
Precautions for small drill grinder
1. Pay attention to the selection of the appropriate grinding wheel for the small drill grinder.
2. Some high-speed rigid drills may be sharpened on one side due to their poor symmetry. Fine-milled drills are better.
