Tool grinder equipment can now be used in many industries because the equipment not only has good performance but also has a good grinding effect. But it is worth noting that when we use it, we must pay attention to some points of the equipment to better complete the grinding work. The following takes BT100 CBN Tool Grinder as an example to tell you some points that need attention when using.
Before use, the power plug and socket of the tool grinder should be installed firmly and reliably, with good contact. And non-electrical professionals are prohibited from installing and maintaining the electrical system of the machine.
Before starting the machine, check whether the voltage and frequency of the power supply are consistent with the motor nameplate requirements. Check the reliability of the protective grounding of the electrical system before starting the machine. Check the reliability of the protective grounding of the electrical system before the bed
In order to protect the operator, the handle that should be locked in the machine must be locked before work. The workpiece should be clamped reliably. Before starting the machine, the workpiece should be clamped reliably. The wheel guard should be fixed and tools such as wrenches left on the machine tool should be removed at will. It is forbidden to operate with gloves and be careful not to touch the rotating wheel and workpiece with the mold to avoid injury. It is forbidden to install workpieces and change grinding wheels on a started tool grinding machine. It is forbidden to install workpieces and change grinding wheels on the starting machine. Operators must protect themselves when operating, and wear safety clothing and safety goggles.
5-Axis CBN Tool Grinding Machine requires maintenance and repair work after use. Before maintaining and repairing the machine tool, be sure to cut off the power supply to the machine tool before confirming safety. Before turning on the power, make sure that the machine tool switch is in the off position. When work is completed or temporarily left, please turn off the machine power switch when work is completed or temporarily left.
If a tool grinder machine tool malfunctions or makes abnormal noises during work, you should immediately cut off the power to the machine tool, check the cause, and remove the fault before you start the machine tool again. Be vigilant when working and do not operate the machine while under the influence of alcohol and fatigue.